For the first use occurred in the new kitchen. The sink base cabinet needed a small part of the flow of going away to the left. It quickly became clear that the wood was too thick for the Boater intent. Although I was able to cut the wood but not cut. The wood is about 1.5 cm thick, the Dremel can only 6.4mm deep cut (which would have been able to know is not mentioned at Amazon).
So on to the second application.
A furniture back wall was too wide. The wood was a few millimeters thick and no problem for the Dremel.
Cut laminate lengthwise: Now for the last use.
I had to cut the laminate lengthwise through. However, the Dremel hardly came through the cured wood.
at the first cut, the saw blade through the wood burned more. It smoked and smoked they were worth. From cutting as could be no question. In the beginning I was able to completely cut through the wood. Once, however, the cutting teeth had worn I was not even halfway.
I do not know what I can use this resolution even if he Nichtmal so can cut thin wood.
The price for this poor quality is much too high.
Pro:
- At your fingertips.
Cons:
- Bad Blades
- Wedged fast
- Mounting not intuitive (no manual)
- Heats up quickly
- Low cutting deep and therefore not usable for almost all application fields.
- Intent overpriced
- Replacement Blade too expensive
- Too short a lifetime