However, two things I find not so successful:
1.The lower receiving the doors should be running eccentric and off-center, so it would be possible to align the doors better. I had to solve a few screws and pull the grill according to align the doors to some extent.
2.The grease tray should be completely reconsidered. The galvanized sheet metal is attacked by dripping. The rivets on the handle are too big and too long. But the best part is the hot glue in the corners for sealing. For me, this seal after about 10 times crickets ran away from the corners and the fat is now running on a corner on the floor below.
This info I have reported to the manufacturer. A confirmation came after a few days. They will change the drawer and I get a new one. Therefore the grill gets 5 stars
For BBQ I've bought the griddle. On can go for a very greasy stuff grilling without the flame / smoke arise.
22:02:14 Now I got the fat drawer, took some time. Unfortunately, you have eliminated the problem nich. Instead of using as the old tin hot glue, you have now bent over a tab. The hole in the bottom corner is still available. I have written to the company again, let's see what comes up.
Mail from me was read but no feedback.
Now I have soldered the corners easy
