The installation itself is very simple.
Fix base rod in the stand, assemble stand on table / fix, monitors mounted on the arms, put his arms on the ground rod and tighten.
==> To the mounting block for the poor is a "one-armed screw", which can be drawn back to then turn back at idle.
With the Allen keys can be the counterweight of gas springs adjust perfectly to the weight of the monitor.
Among the poor are inlets for the grommet. For me, keep as but either the current or the monitor cable. Both I do not get clever stowed.
What I had not considered, is the place, the arms need to get out to the rear, so that you can adjust as desired the monitors. Since my desk is right next to the wall, the monitors now protrude about two-thirds over the tabletop, making them much too close to the viewer. Thus, the holder must unfortunately give way to a static alternative ...