Good functionality with a few drawbacks

When changing wheels with screws that have been tightened to 130 Nm, were the most after 2-4 s
solved. Only 2-4 were set obviously. After about 20-30 s also dissolved.

So you could say, screws to 130 Nm are achieved very quickly. Make higher torques
obviously more problems. I can not say that the torque had just however.

Note would aluminum wheels that the nut is long enough, otherwise the impact wrench quirks in the
Rim strikes and possibly around the screw rotates, the nut if it does not completely enclose.

Because: The screwdriver is very powerful to the point. Even after tightening feeling on a certain torque
I would not recommend. The screwdriver does not have a "sensitivity", but is well suited for coarse material (stable, strong).

By the way, that the screwdriver is very noisy, but this matches the behavior described above.