The housing is quite stable, but the distances between the solder pads on the circuit board and the housing are too small. Here missing a thin film for insulation, otherwise it can easily lead to short-circuits the power supply. I have cut the film required for isolation from a blister packaging. This leads me to the devaluation on three stars!
The supplied screwdriver does not fit well with the very tight screws.
Even better would be the case when the board was not inserted into the housing. The Samsung SSD produces as much waste heat that it is warmer than 85 ° C after approx 50GB data transfer with ROBOCOPY and then significantly reduces the data throughput. It when the SSD may become jammed in direct contact between two housing halves would be nice. This would significantly improve the heat dissipation! OK, the different geometries of the SSD's from different vendors makes this course not easy, but you could use thermal pads as compensation.