I had bought in the past, a stocked Zinc plate. Now I hattei left two 2,5Zoll disks and am therefore went to over to buy empty housing to bring the plates also visually extremely appealing under. The build quality is good outside, inside rather moderate. The fit is right, the controller is 08 / 15Ware. The correct assembly takes a bit because it's a bit fiddly, but everything fits, the panel does not wobble. The USB 3.0 port has been fixed in my cases by soldering points. The reviews of other reviews so I can understand only partially. The port will also have stabilized by the housing. In normal use, and not 200 times plugging and unplugging of the cable I do not believe that the controller board with the port is damaged it. Moreover, even to other reviews: It acts with the supplied screws to Torx6 housing, a common format nowadays, who does not have such a screw driver or bit in his toolbox at least not very well equipped. Of course, it would be part of CnMemory sense provide an explanatory tool, no doubt, but a T6 is now nunmal not so extraordinary as it reads here. The design is of course phenomenal, easily trigger wg. fluctuating quality and light quality defects.