Inferior glue, inferior material!

The material makes the extent NEN good impression; very hard plastic and the spikes hold the boot reliably determined in a position.
The problem is the adhesive!
The detailed guidance recommends that the adhesive and the fat-free board is to fuel with a hair dryer; as should be handled with the adhesive surface. After bringing the pad into position and makes everything a little pressure to cure for about 24 hours.

After the Board now has a week in the apartment was with me on the ground, thus ensuring enough time to cure, had the pad slipped while lifting just by the Board and I discovered that the glue was indeed dry, but not connected to the Board had.
There probably remains only the handle for double-sided tape.
Next week I will then times this combination in the winter holiday try for a final feedback!

EDIT:
After a week of snowboarding Unfortunately, I realized that now the material temperatures of -5 ° C yields, tears and breaks. The items I could not find. The last remaining fragment is certainly not enough for a return.
I am extremely disappointed by the article and must say each potential customer a WARNING !!
The pure garbage!