Here are my problems and the solution to:
If you have connected the receiver to a single satellite cable, you should not select the menu of the receiver as possible the "Einkabelbetrieb" option. Who turns this mode, is may Gar can not receive a picture.
My satellite system consists solely of a key of the satellite using a universal LNB Quard. It is interposed no multiswitch or other stuff. My previous Topfield receiver was substantially easier to install in this case. When operating with two cables, the installation seems to be much easier.
This setting in the menu will solve the problem at single-cable system with loop-through operation
Single-cable system installed: No
Tuner 2 Connection type: Loopthrough
Tuner 1 & 2: Simple LNB (the only way to the unneeded Antennsteuerung DiSEqC switch off)
Dear team from Kathrein: Cleans times please your menu for the single-cable system.
The 50 cents per minute for telephone support are an impertinence!
Fan control: The best "make Automatically" on. Then, the fan hits only when needed.
I would buy the device at any time.