Little wrong track

Through other reviews I was forewarned, also came by the supplier before the arrival of the card by e-mail a note to installation problems. It should / would have a different driver will be made up of its support page. This page is initially only English-speaking and quite confusing. One way to language will only be available at the bottom right. Find looking after and scroll. This is part of the usual way to the top of the upper right and must immediately catch the eye. A Renesas USB3 Host Driver-30230 I got myself and also used to install the card in advance. But that was a flop, because the well alone was not enough. After some back-and-forth, I found apparently the right way: First, the installation of the CD launch. After that appear in the Device Manager only two Fresco Logig xHCI - entries. The other half still feht and USB3 port remains deaf. Now start the retrieved Renesa setup EXE, so the rest is done. After that appear in Device Manager, the two entries of Renesas Electronic. And the drive is first detected. Only later I realized that installing two autostart Eintäge in the Run key of the registry was created. Whose meaning could not be determined and I then turned off - with no visible impact on the operability. Even though it is this is a fairly inexpensive and optimal part, positive: no additional electricity and for the PC front nor the 20-pin auxiliary port, a driver CD was supposed to be up to date. It seemed to me exactly to those two characteristics with the terminals. Unfortunately, the joy did not last long, after about 24 hours with several restarts (if Windows Update) was no longer the card and was no longer to activate with all the trouble. Obviously, a conflict was with the board-USB3 port before on the PC back of which uses similar driver. But I wanted to improve and use the two remaining unconnected terminals Front. Now, the card goes back because of unavailability. An installation of this card should be better avoided unless the motherboard itself has a USB3 port (on the back) and used similar driver from Fresco Logic. This led obviously on my PC to the conflict. A new improved USB3 card (KTU3FR-202i) could be installed without error regarding drivers.