First attempt: sheet slightly overlaps the edge and must be removed again
Second attempt: Although display clean, landing some dust particles (from the air?) On the adhesive side of the film. Trying to remove them, resulting in streaks. No matter up with the film!
But although it now looks fit, it does not seem to stick at the top right. Also I get the bubbles rausgedrückt neither the finger nor the credit card.
Third attempt: Somehow that but his hinzubekommen when it obviously works for all the other so simple and great. So again, the film pulled off something and draufgebappt again. Now more dust particles are on the adhesive side and some are surrounded by bubbles. Top right sticks's better, but still not right. The streaks that are caused by my attempt to remove the first grains of dust, also do not properly send impression.
Result: The cool touchscreen phone looks as if it had the last 20 years located under the sofa. Therefore deducted foil and thrown in the trash. I could now invest an additional 10 euros for a second attempt, but I am afraid that that is not much better end and decide to treat my phone unprotected future especially affectionate.
Two points I admit, because the film itself so was fine and the problems caused by improper use. However, my product does not appear to be suitable for the mass of consumers, because at least to me it is not clear how to achieve the necessary apparently perfect precision than mortal.