At the table clamped = was great, absolutely stable.
Press plate hochgekurbelt = fell slightly, good Ueberseztung.
Plate outward turn away = possible with a lot of coaxing and cursing. The screw is this "jib crane" leads made of soft material. Hooked, jammed and if one uses a little more force, the retaining ring raises the Fuelltrichter. The one must then plan kloppen again because he is -eigentlich- arritiert with screws that are overexcited but at the factory. Beats or presses you do not return to the ring, the distance is no longer around to be able to trace back enough to drive.
Sausage purely of: filling easily.
Start cornucopia: Alibi bayonet lock. Holds, yes, sort of. Should burden to the horn not. Durchdruecken mass goes. But do not turn rumdoktorn when you should have what stuck in the pipe.
Sausage press: Right after the first 3cm it turns out that more sausage hochmatscht around the printing plate, as below arrives. Around 75% of sausage meat is then on the plate and must laboriously hochgeleiert be rausgepuhlt of the greased with machine grease holder together with all slots and screw holes.
Down in the last part of the appliance to collect 376 grams of mass which can no longer rausdruecken.
When cleaning your device: With pliers and screwdrivers, you first have to disassemble the whole thing before you can see the actual cylinder. The screws can be 2-3 in and out turn, have then they are sheared.
Conclusion: Stay away! This looks just like a Wurstfueller.