Installation is possible even without the usual (and often non-existent) long socket wrench - thanks to a screw connection of the mounting pipe with a "giant mother" (goes slightly by hand) and subsequent fixing by means of two simple slotted screws with a normal screwdriver.
Spacer or stabilizer adapter piece for thin stainless steel pool is also included.
Initially, the big thing was getting used to, because this one hand high spout rises but then still a good 22 cm deep into the sink into it - just as in the measure sketch seen. Since then injected fast times over the pool edge before, but after a certain conversion time does it quite well.
(Unfortunately, there are hardly any where intermediate size-fitting - so about 18 cm projection - which would be ideal for my purposes ...)
Surely this problem falls away when the valve is being used "Dedication accordance" for a sink. The high spout fit securely as well for larger pots and "bulky" things.
The operator Feeling both when swiveling and dosing is however in this heavy equipment very well: gentle, full and smooth! (With my old cheap model that was not nearly as!)
Let's see if it stays that over the years, so ...
The connection hoses are even too long for a standard wash basin - had to twist the angle valves in order to get another "turning radius". (Looks but thanks anyway shoring no ;-))
The O-ring seals well from the pool and can be outside a small gap free for the rotation of the main pipe. So far, not a single drop went through down.
That the chrome finish mercilessly manifested any water droplets called "edge-drawing" have probably all similar fittings together -. Because you can only possibly to another surface change (brushed finish or so)
Only a temporary, small Blubber-noise when opening the tap irritates me a bit: After a short pause which comes again and again on - but without that, for example, the Perl outlet would drip and therefore only possibly an air hole would be filled.. It can not be determined, where that comes from - but is not so bad ...
And by massive, large construction I would imagine that a lot of heat is lost to the brass before the hot water high- and finally comes through the wide spout out. Energy saving should not be ...
All in all a very noble part, which I enjoy - and all that at this affordable price! Thank You!
