I bought a repeater to extend the wireless network over two floors in an old farmhouse. My wireless network is created with a linksys wireless access point, which depends on the router. the installation of Fritz! Repeater is designed as so often mentioned, very difficult. I think for beginners without WPS router is nothing. But now to the device itself: After manually setting up my wireless network, it took a few minutes for the wireless expansion stood. the operation of the device itself is a little difficult. it happens very often, that is not recognized, the input via the touch panel. then you have to press a finger on the panel just a few times until something geschieht.ich think it has something to do with the lighting conditions. if it works for me, works of repeater very neat. the transfer rates are satisfactory to very good. as I said, but only because wenns works. one of the worst fads of this part, it is namely that it a try can not connect to the access point. with the notebook and even ner PSP has 100 percent empfang.nur the repeater sees often nothing. or the repeater 100 receives percent, then passes the signal but no further. I have a part at least 10 times refurbished. it's time NEN half a day or even for quite a week, and then suddenly it's all over again. (see above) I think about NEN wireless router Fritz! to buy. This should work fine thanks "WPS" Combining yes. my conclusion: a good per se device which unfortunately until now has massive quirks with me. therefore also only 2 points from me.
Addendum of 08/10/2009
after I bought a WPS router from Linksys, is the operation of this device without any problems. except for the poor usability through the touch panel I am very satisfied. I raise hereby 4 stars A small note: with me is the repeater on the address "Fritz repeater" or so unfortunately unavailable.