Essentially, I agree with the good reviews with the following restrictions: * The LED work light switches while pushing the power switch (contrary to the instruction manual) only one, albeit the engine starts. Illuminating the cutting area before Sägebeginn not possible. * The rip fence / circular (which is why I bought the 1000s rather than the 900) does not match the rest of workmanship and material quality. In particular, the locking screw is not very reassuring. * The anti-splintering device does not last long. If the blade is somewhat, the gap is wider in sawed-splintering. Because of these restrictions rather small I would give it 4.5 stars, had not yet had my copy a problem that restricts the use of strong: * The swing was "0" is not completely shut down to position. Fine cuts or editing thin materials were therefore impossible. I can not say whether this was an isolated incident of my copy. The manual describes namely the possibility of disconnection. I therefore recommend to check the Pendelungseinstellung after purchase (best done with a sample workpiece). My saw was as "defective / not functioning properly" back, the withdrawal within the return window Amazon was handled smoothly and quickly. For the defective copy I forgive 2 stars.
