Install the system went without problems.
The app for Andoid has also provided the same firmware updates for the gateway and the lamps.
The update for Gateway went smoothly.
Had first problems when updating the firmware for the lamps, it took some time until all three lamps have received the update.
If a lamp has received the update, turn on white light.
The app allows the lamps together to form groups, individually or turn on the timer.
In the View group of the App (Android) can tap man of color wheel and here in the new image above right, select the icon for the scene creation.
Unfortunately I did not make it a scene eizuschalten per timer, off by timers funktionier however.
Typing in the group view take on the color point, the group name, then you can edit the group.
Name of the group or lamps can be changed directly in the edit mode, if you type in the name.
The amended lamp name is taken directly into the group.
If you type in a group or lamp view on the dot,
can lay man with the heart symbol on the right side in the middle, colors as favorites, you (again the heart symbol) can recall directly on the bottom bar.
Currently 16 color favorites can be stored.
In relation to the AndroidApp version 1.1.0.b2
When switching via app is the last point is color and brightness enabled.
When switching via light switch is white and 100% activated
(This is done even if the switch is actuated and there was a Stomausfall where RGB garden light to violet active)
Reset the gateway via buttons on the gateway,
the lamps on light switch for 5 sec. on, 5 sec, and the times in a row 5,
or in the app under Settings and "System reset" at the bottom right.
Additional: for some reason are gone with me, 4 of 7 timers, so I'm going to watch.
Incidentally, when the timer setting "Start 22:00 End 06:00" is not working.
For Timer 2 must be applied: 10 p.m. to 23:59 and 00:00 to 06:00.
Addendum of 25/06/2015:
after the update of the gateway and the lamps the function of the lamps has become more stable.
Means you no longer fly out of the ZigBee signal what used constantly happening.
The on state of a switch of the lamps can be divided into the app set (brightness and color)
Timer problem is still not resolved, sooner disappeared 10 timers 7 and the 3rd present was broken, this one had to recreate it.
Now disappear 8 of 10 timers after a few weeks and the 8 timers must be entered again, it sucks.
It can be for 3 RGBW LEDs and 2 Ligtify strips create 10 timer, this is not enough because you need to use Timer 2 already when switching on the nights day.
Timer Example: today 22:00 to 23:59 from 02:00 from 00:00 tomorrow. This can not be solved with a timer.
Color selection at the RGBW LEDs is a coincidence undertaking, especially in blue and green.
I have reduced my rating of 4 stars on 1s because Osram it today does not manage to eliminate these problems.
In addition, I have some time ago found a website, which shows the that sent Osram to test for a few weeks, the system tester on and these problems are mentioned.
See: [...]
On the positive side, I can finally the Lightify team highlight who always responded quickly and friendly.
Had on several occasions made contact and all the problems just described.
However Troubleshooting takes far too long, and promised features have not been implemented to date.
Just the color selection of the advertised 16 million colors is not possible !!!!!
After this time, as Alpha testers, even though I am an end user, I would by no means the system re-sale,
There is way over priced and time consuming.