I purchased this product in a DIY store because I have repaired urgently. The product is expensive .... but gave me any satisfaction. I had memorized the advertising video of a DIY store (I did not believe much ...) A plastic part of the swallowing mechanism of the doors of a tourniquet (dead corner kitchen cabinet) was broken and some of the small broken pieces were missing from lontemps. I'm talking about 1mm wide tracks on 2x 5 mm, approximately) First I glued small moreaux present with cyanolite because with Soliq must light can reach for bonding (the curing of the adhesive with UV) happen. Then I reconstructed the missing areas in small successive layers Soliq: it's easy pipette is fine and with the UV lamp is made by taking 8s. Within minutes I had reconstructed the missing items. I had no place to sand as stated on the instructions but it worked very well run. Then I adjusted by cutting the cutter (that is a very precise piece that was broken). It's easy and I found that the zones made of Soliq was more resistant than the original zones. As I had some areas of thin I put small pads reinforcements soliq. Meanwhile I had found the manufacturer of the part (rare German product) but it only sells complete -ensembles under both say that for a play I should pay the price of 20 times more material.