Beurer UB 67 Cosy - clamping Wärmeunterbett, white To preheat the beds and sleepwear currently 2 Spann-heated mattress pads are in use. Both packages kamem in talellosem state, all the necessary parts were present. The mounting of the bed occurs as the rearing of fitted sheets, also in this case because of the good fit easily and almost unverrutschbar. Also, there are good results with respect to the heat development and distribution. Set at the highest level, are the beds by rel. a short time (approx. 20 ... 25 min) pleasant and -over the area distributed in the area below the pillow - warm. On the bottom, the temperature is increased. The blanket provides a thoroughly pleasant lying feeling. With 2 beds side by side you want most, that an electric connector on the left, the other is positioned on the right side of the bed. If the ceiling with the space provided soft side is up, this connection is standard - seen in the direction of Liege - on the right side. In this position, the electrical connection is well padded and interfere in any way. Quite different is the situation with the electric connector of the ceiling in the other bed. Here you can either move the blanket just like on the first page and do not know what to do with the switch and the power cord, or you put the ceiling upside down. This has now though the electrical connection on the right side, but this turns out to be hard, disturbing square block. He is not, as on the soft side, protected by any padding; Anyone who has ever struck with the elbow against a doorpost, understands the pain that can occur :-)! With 2 electrical connections would this annoyance from the world. When the power cord is a little flexible cable, in which the switch is integrated. This shows through integrated lighting on the selected heating level (0-1-2-3). If you want to turn off the ceiling, it is necessary to consider the direction in which the 0-position can be found. An additional 0 position - behind the '3' - there is not.