I own this printer for a little over a year, here are the results: - Print Quality: The quality is really to go, especially for text printing. As against the images may contrast with the standard resolution setting, but the quality is significantly improved by opting for maximum resolution. - Speed: The printer is really convenient to use, in fact it heats quickly enough, then the flow is quite satisfactory. Personally I took it to replace an ink jet that had exasperated me by too frequent replacement of expensive cartridges. Balance sheet, despite the heating time, it is faster than any jet inks that I used until now. - Silence: The printer is satisfactory. Three phases can be distinguished, she quickly goes into sleep mode, in this mode it is completely silent of course. At the launch of the impression it enters heater mode, there it actually made some noise, but it does not last very long. Finally, during printing noise is moderate and in any case I would say less stressful noise of an inkjet. - Reliability: This is the weak point of this printer until then we can say we had a bluffing printer, and for one year I had no worries, no paper jam during this period. By cons one day she refused to run, it was still under warranty for 2 weeks. Diagnosis: HS gear oven. Considering the other reviews it seems scouring on this printer, the gears of the transmission appear to have a fairly short life. - Conclusion: A printer that really impressed me, perfection until it fails. Now when you see the purchase price, we can consider that it can remain a good deal, it should be considered as a consumable that will go to recycling after a year or two.