The movements appear to be working; although they tick differently "(have 3 earned) ZW (should probably be a pointer shaft; I suspected, this is the part, which then rises through Ziffenblatt Overall it is, the ZW, of course, much longer.):. specified measure but was just missed; and the indication does not say, for which a maximum dial thickness the movement is available had therefore asked for another axis screw contact was (seemed) nice, new screws should come However, this took longer than promised, and instead.... three were in the end only two. All in all a dime in the truest sense of the word. pointer must incidentally be ordered separately, and not all that usually fit in such movements, are suitable for this purpose. The three stars are there that at least something of the will was seen to solve the problem, which could be avoided with a qualified presentation.
