Stay away if you really want to work

I bought the set to fight so that the house expansion. Have been processed so Holzbbalken, OSB plates, stud walls (thin plate and steel), window frames. Was used a 18V Makita up to 80NM torque hard

Negatives:
- Drill all dull. Stone should through the thin sheet of the stator frame, and then in the Ytong wall -> Takes forever and needs a lot of pressure.
HSS takes forever through window frames (from 6 to 10). Small break fast because they do not cut and you have to exert a lot of pressure.
Wood gets hot and starts.
- Measuring tape is only the rattle
- Water balance is just better than the App in the smartphone - Since just buy ne Sola!
- Bits are immediately around if they are to turn times 10 screws in wooden beams - best buy Diamantbits. Cost 5 at the hardware store, but keep loose 6x so long.
- Trunk is stable, but you get the accessory hardly get out, even harder to not at all clean again.
- Missing a decent bit holder.

Positives:
- Wide range with all standard sizes.

Conclusion:
Since the recession partly go so far apart, I wanted to give the case a chance. Unfortunately, the best Zugbehör has from the hardware store endured over the accessories from this Makita set. It just swallows only money (yes well ... there just is not much) and a lot of time at work.
IT'S ALL IN ONLY TO USE the least!