The plate came today via PIN AG in two Amazon Typical flat package into the mailbox. Without traceability, I find it a bit daring!
The plate itself is dependent on me at one USB3.0 adapter, but is installed later in a Intel_NUC.
After commissioning, the peculiar, occurring sporadically completely Fiep / beeping noises are immediately noticed. Sometimes the coming several times a minute, after a quarter of an hour no sound, even at capacity utilization.
So far I could find absolutely no relation to the utilization of noise or power management of the plate.
If someone experiences or even data loss with his record has please report times. Unfortunately I was not able to figure out
whether the noise is an indication of poor quality or is ignorable. I'm more reports if there is something new.
EDIT:
Techn.Daten
REV. A
Model Number: HN-ST2000LM003 M201RAD
Firmware Revision: 2BC10001
Transport: Serial, ATA8-AST, SATA 1.0a, SATA II Extensions, SATA Rev 2.5, SATA Rev 2.6, SATA Rev 3.0
Configuration:
Logical max current
cylinders 16383 16383
Heads 16 16
sectors / track 63 63
-
CHS current addressable sectors: 16514064
LBA user addressable sectors: 268435455
LBA48 user addressable sectors: 3907029168
Logical Sector Size: 512 bytes
Physical Sector Size: 4096 bytes
Logical Sector-0 offset: 0 bytes
Device size with M = 1024 * 1024: 1,907,729 MBytes
Device size with M = 1000 * 1000: 2,000,398 Mbytes (2000 GB)
LBA, IORDY (can be disabled)
Queue Depth: 32
Advanced Power Management level: disabled
Recommended acoustic management value: 254, Current Value: 0
Cycle time: min = 120ns 120ns recommended =
Cycle time: no flow control = 120ns IORDY flowcontrol = 120ns
## 05/06/2015
ID # ATTRIBUTE_NAME FLAG VALUE WORST TYPE THRESH UPDATED WHEN_FAILED RAW_VALUE
4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 3
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 3
194 Temperature_Celsius 0x0002 064 064 000 Old_age Always - 33 (min / max 23/33)
225 Load_Cycle_Count 0x0032 100 100 000 Old_age Always - 14
Read:
hdparm --direct -t / dev / sda
Timing O_DIRECT diskreads: 368 MB in 3:01 seconds = 122.15 MB / sec
Writing:
dd if = / dev / zero of = bs = 1M count tempfile3 = 1024 conv = fdatasync, notrunc
1024 + 0 records in
1024 + 0 records out
1073741824 bytes (1.1 GB) copied, 15.0672 s, 71.3 MB / s
## 05/14/2015
I use the disk (even if it is not made for it), and have now found the optimum setting for me in continuous operation under Linux. By default APM is disabled in the plate. After I put on 254 with hdparm -B parked the drive only after the set spin-down time (hdparm -S 120) with me for 10 minutes. The peculiar Fiep / beep I have only heard about so every 2 days ago. Also interesting is the the Load_Cycle_Count the board is increasing by 28 per hour in the delivery state. After my attitude he has fallen to 8 per hour.
