The guide is not only bad, but it is definitely wrong.
An Example:
The walls on the left and right of the door are called P3. In the manual, the P3 wall around the corner going around. However, no corner in the wall is preformed. What now? Same Bend? No! That's just an error in the pattern. Later a wall P2 get there and the P2 is around the corner.
Another example:
Get to the top and bottom doors crossmembers bolted. They have all the parts designation 20. This suggests that they are all the same parts. Nope, not at DEUBA. The hole is added at two of the four of them slightly.
Another example:
The framework, which goes around once at the top of the walls: On the back are located dor two U-frame overlap, so two holes are superimposed so that they can fix it with the self-tapping screws. It does not work !! is too short! For this you can fix it with one screw at a different location.
Another example:
In the manual is: 2 persons, 2-3 hours.
That's not true!
If you follow the instructions, then you would need a minimum of 3, rather 4 people! Because according to instructions, the walls are bolted right and left, front and rear left and right first. So there you need a person who holds two front walls and rear holds two walls. The gaps are then filled with other walls that must also hold someone, so you can screw this.
TIP: First, build the walls around a corner and fix to the rails in the top of the walls. Then is the also must hold without anyone.
2-3 hours is also not true. 7 hours are realistic, if you have not ever built the thing. BECAUSE THE INSTRUCTIONS WRONG and incomprehensible. So then you have to repeatedly unscrew back and try different.
A harmless example dagen is still that one should connect to an F1 screw (sheet metal screw) with a nut. What is not natural. Here were meant the plastic washers Probably.
Every third tapping screw does not cut. You must look for a new one. This takes time! Ultimately nevertheless enough Bleschschrauben were inside. So does DEUBA by the poor quality.
Sometimes a self-tapping screw holds not because the hole at ausleiherte reindrehen.
Parts were already battered in the box. Well, that made at the end of anything, because you have to press and turn anyway here and there. Worst of all is the panel to the door frame. The must then be bent so that the door without toast and can "slide".
When you build one thinks often that the holes are in the wrong place. TIP. One has only to again loosen the screws near, then pull with power and skill the correct holes superimposed. Then you can tighten the remaining screws.
Once it had but definitely not work because had drilled a hole.
See the door handles on the photo look like metal. However, it is plastic.
The roof edge get even a flap and the corners of a protective plastic. The trick is to get shut with a 2.5 cm self-tapping screw swohl by Plastic Kecke, two protective strips and then through the hole in the roof. And the same four times ...
The installation site was not the final position because of the scales should be positioned close to a wall. The scales only move with extreme caution!
Now that the scale is, the stability seems to suffice. Clear, may lean on you do not.
Would I buy this thing again?
Well, that's hard to say. There are either those Presikategorie by others, or even equal to 2.5 times more expensive. Would rather save money for my purpose. I I was forewarned by the other reviews. If you are planning a shed for more than 10 years, I would definitely buy something with quality.
