Commissioning has lasted less than an hour:
- Connection to the LAN, to access the web configuration interface
- Load the provided by the manufacturer in the Web configuration Vigor130_Konfig_ADSL_VDSL_Modembetrieb.cfg
- Change the admin password
- Connection hinter'm router (which also previously had been running with Modem Bridge)
- Sync! Network access!
Said Config also takes care of VLAN = 7, VPI = 1, VCI = 32, PPPoE = off, MPoA with Brige = on.
By default was on firmware 3.7.8. I then still the same firmware on "Modem 7" flashed if the Telekom will also eventually wants to introduce vectoring. Even with this firmware there is no problem with the sync to VDSL 25th
Speed (measured by computer image DSL speed test) is very close to the theoretical Maximum in.
Another tip: the unit is generously covered with protectors, preferably through the ventilation slots. It does the life and safety well, ensure that none of them overlook ...