The lifting straps are made of a robust cotton fabric band and have a length of about 570mm and a width of about 40mm on. On the left side there is a double-stitched loop of about 40mm diameter. Right next to it, but at the back there is a neoprene padding of 150mm length, 45mm width and 4 mm thickness. Centrally located on the neoprene padding on the front of the sewn Best Body Equipment Germany Logo. The lifting straps are delivered in pairs.
The application of the traction device is simple: Carry out the right end of the fabric strip through the loop on the left, the resulting large loop strips so on the hand that the Best Body Logo user from being considered legible and pulls the loop in order to determine the wrist. Now you hold the hand so as if to grasp the barbell underhand. Now the strip of cloth should be on the palm. The cloth strip is placed from above on the barbell and even performed the barbell until it is just below the longer end next. The final step is to roll only closely. (Depending on your preference either clean superimposed or in semi-overlapping windings) Done! Now the hand does not have to hold the entire load of the short- or barbell but only secure the strip against unwinding, the weight depends virtually on the wrist. Similarly, now proceed with the other hand, although this requires a bit of practice since this now has to be done with one hand. (A hand is already on the shelf "chained") I recommend using the ungeschickteren hand to start;)
My conclusion: Inexpensive, solid processed and well-padded Straps fabric. 100% buy recommendation!