The processing and especially the insulation is fantastic.
If you now not all turned up on his fans to over 1000 U / min, then hear nothing!
Absolutely nothing.
When I put this computer every three anschalte, then I have to look at the lights on the housing to insure that to me these things are really up to.
Processing:
Top, all I can say! I'm fine
Installation:
at least for my board and power supply are on the right places holes in the housing to all cables to make them disappear in the rear wall.
Hard drives ready to be pushed in and out, thanks to the existing plastic frame.
Insulation:
Each removable part is insulated.
Fan:
Front and rear is a 80mm fan in it. One could still loose 2 more installing.
The fans are at least at the front, where they are protected by a removable suction filter.
Gimmik:
A slot for a SATA drive is present. So just slide the disc into the slot and it runs. Good Idea
Cover front is shiny and snaps with a full "whistles" via magnetic again when you make them. I like it very much.
UBS3 and 2 as well as an SD card reader and AuxAnschluss is above the housing cover available
Conclusion:
Top housing. Barely perceptible in operation. Fan power is great.
I'd just buy me the same case for the next render slaves again!