Due to good reviews, I decided to provide my new iPad not having any, but with a atFoliX. The delivery was as usual from Amazon, straight forward. After unpacking, first of all read the assembly instructions thoroughly. When I wanted to start the installation, I noticed that to be bent "engraved plate", the lt. Installation instructions backwards and withdrawn, is clearly placed on the wrong side. The assembly begins thus inevitably on the side with the home button. If the film is not absolutely accurate (in 10ths of mm range) is set, the film is on the opposite side of something in the camera. Had made the "engraved tab" on the side with the hole for the camera, which would be unproblematic. Because if the film reaches 3/10 mm in the home button or not, is irrelevant. So I tried to work as closely as possible. And I had to peel off the film several times again and start again. But since I have no sterile operating at home, the result was not convincing. At least 10 inclusions graced the screen. the reference in the assembly instructions, with scotch tape to remove dust, works m. E. only under laboratory conditions, as you would fix the foil. Without more hands that is hard to make. Since the scope of delivery includes 2 films (the manufacturer will know why), I have disposed of the first attempt, the display carefully cleaned and started a new experiment with the 2nd film. To make a long story short, the result was also crap. Thus, 16.79 were complete for the ton. The article therefore receives me 0 stars because only Amazon deserved star for fast delivery. The film for the iPhone 5 is similar. Only due to the significantly smaller area not quite as problematic.