a bit more info

How to connect AD2000-M
For those like me who do not speak English
On the terminal you have 8 screws:
The power supply that comes from your transformer 230 / 12V (entered):
Rep 1 (+ 12DC): + 12V
Rep 2 (GND): the 12V
Output contacts:
You have 3 options: 1 contact 12V or 5V 1 1 contact or direct contact
You must choose how you want to control your device that is connected to the output.
On the deck you have a small jumper J1 Rep
Either you put in NC (contact closed) or NO (open)
Rep 3 (Push 1): this is the common (or neutral) of all contacts
Rep 4 (lock): + 12v output
So if you want to control a device (electric strike or otherwise) that works 12v
Rep connection 3 and 4
5 Rep (open in): + 5V output
So if you want to control a device that works in 5v, Rep Connection 3 and 5
6 Rep (open door): direct contact output, Rep connection 3 and 6
(This is what it took me to replace a pushbutton AD2000-M)
Rep 7 and 8; it is a direct contact (for your bell) controlled when you press Door Bell (blue) on the front of AD2000-M

Now a bit of commissioning.
* The password system (MDPS) is 12345 by default, you can change the:
Press #, type 12345, type 1, type your new MDPS (expl. 00001)
To return to the plant manual (12345) this is a simple RESET
Disconnect Rep 1 The power supply (+ 12V)
Put the little rider Rep S16 which is on the plate on the 2 and 3
Reconnect Rep1 (+ 12V) => alarm and all LEDs clignotentent
Disconnect Rep 1 The power supply (+ 12V)
Replace the little rider Rep S16 which is on the plate on position 1 and 2
Disconnect Rep 1 The power supply (+ 12V)
Ok MDPS is again 12345

* To enable RFID (me jappelle badges that this is simpler)
We must identify the badges, jen am 10, so the first I put the ID 0001, the second ID 0002 ect)
There must be 4 digits for ID badge
We take the badge ID 0001:
Press #, enter 12345 (this is the MDPS if you do not wash changed)), type 2, type 0001 (ID badge), approached your badge on the AD2000-M that it detects, and type 6
There, done the same with the other badges but especially not Dont forget to change the ID badge (0001, 0002.0003 ect)
PS: I think it happened that some mest badge wasnt detected, so I débranchai the + 12v and rebranchai, and I rewrote the manipulation.

How to enter a user code on the keypad
* User ID (4 digits) are set as a result of ID Badges
Example for me, I put:
ID (Father): 0011
ID (mother): 0012
ID (1 child): 0013
ID (2 children): 0014
Press #, type the MDPS 12345, type 2, type 0011 User ID, type the 6 digit code you choose and type 6
For my part, each person in my family to its code.

There is other options I'll let you discover ..
I hope that this will help you
Looks like Florence, A plus on the bus