Here are some tips for fitting:
- Laying Before attaching or before removing the adhesive surface, the film simply want to display it, to get a feel for how this will sit later / needs. In the film's S4Active for it is true that these fills to the brim full screen - without any tolerances. In German: This film has to be placed with absolute care and precision, because if on the one edge side is too much play, it is on the other side edge over.
- Switch off the mobile phone, clean the display. Ensure dust-free environment, ie window, heating off, let calm air. Hardcore film Adhesive supposedly go in Bath's and generate the steam from the hot water a low-dust environment, but that would be too uncomfortable.
- Take time: To accurately install the foil, you like requires a quarter of an hour.
- Tesa film strip lay cope. It takes usually six to eight Tesa film strips with a length of approximately 2cm
- Depending on a scotch tape strips above and attach a the bottom of the top of the film in order to "touch" the film so can. Now remove the protective film of the adhesive surface. NEVER (!!!) to touch the adhesive surface with your fingers.
- The film to the adhesive tape strip to hold and position on the screen. That's absolute Frickelarbeit, I have at the S4active film ten (yes, 10!) Attempts required until the film finally sat 100% accurate. Take care at this time not to air bubbles or dust particles - the fit was here first higher priority. Sits the film on one side is not perfect, it is on the other side and can not stop there. It hurts the film not if you gently again raises / detaches with the scotch tape and new touches
- When the film sits perfect in every way, then we proceed to remove the air bubbles and the dust: air bubbles can simply slide out with a debit card. But if a dust particle cause the bubble, so it must be removed by the foil slightly lifts with a scotch tape to the Mote. The particles stick to the film, so we now take another scotch tape stripes and polka dots the film with the Tesa at said location from below slightly, so that the dust will stick to the adhesive tape.
Really, that works - you can see the dust particles so gradually remove. I have just just attached the sheet on my S4active and had to remove about 10 dust particles - worked completely. Please make sure this dassihr neither display nor foil base with your fingers touching, because the spots could leave.
Done. Display protected :-)