- Simple source and target plate insert,
- Switch on the device,
- Haberdashery until the two plates are under way shortly,
- Press DUPLICATE button briefly and were until the red flashing light goes out again,
- Press DUPLICATE button again .. copying starts with glowing blue LEDs,
- Now were depending on disk size 1 to 2 hours,
- Have at some point all LEDs copying is considered finished,
- Switch off the device,
- Plates refer,
- FINISHED
Since you can not go wrong.
But you should already know that
SOURCE = Source drive and
TARGET = (copy) target drive
means.
---
Because basically I use the device only for data back up, I can see the other functions of the
Not judge device and therefore do not evaluate.
---
When I look at the reviews of pre-reviewers, is because they contain so many errors:
---> The shafts are now labeled and an interchange of source and target impossible :)
Mixing and accidental copying the wrong way is the very fact impossible because:
>>>> The Klonplatte must be the same size or larger than the original disk and must not be formatted or partitioned.
Even the sentence:
---> Target and source must be the same size. Although not the memory is completely exhausted on the source.
definitely wrong!
1.
The plate is physically in sectors copied, regardless of whether data contained on those sectors.
. 2
If you copy a 100gig a 160gig, all partitions are copied 1: 1 (if only one = C then only one partition).
The remaining space can then arrange PartitionMagic the C partition or with Windows-board means simply an additional
Create a primary partition and assign an additional drive letter. I advise them to use from then D, E, F or G,
because there the CD / DVD drive and USB flash drives connect. As useful as I consider letters W, X, Y or Z.
Frank