Processing:
DB-Killer is screwed with a special screw. Torx with internal pin or whatever to the grumbles.
This I had to tighten it not for the DB-Killer stuck properly.
The lasered in the retaining plate lettering had back leftovers from lasers. That's better.
Otherwise I am, taking into account the price, satisfied.
Accessories:
Everything was there what you need for installation.
Fit:
Rubber stoppers for center stand stop fits.
Cylinder connector fits.
First was ok attachment point below.
However, the plate was then attachment point for upper / Auspufschellen some distance.
Because the muffler is not around you can see the clip does not rotate in position.
In order not to completely reset the system when the screws are under stress I have
a spacer and two 10 washers used.
Thus the plant could be relatively fitted free of tension.
Appearance:
Ansichtssache
After 6 months of use:
Meanwhile, the exhaust rubber, made the rubber seal between the clamp and muffler from the field.
This was caused not so great fit of the clamp on the final pot.
The DB-Eater is loose.
This is a special screw, Torx with pin, attached.
Despite existing tool it was not possible for me raus the screw or purely turn.
End of the song is a botched screw receptacle and a further rattling DB-Eater.
Remains ultimately only boring yet.