I like but good

EDIT MY COMMENT:
My camera was defective goods: it was abnormal that it loses as much water. He completely stopped working in July (water not heated) or 4 months after acquisition ...
SAV-up was a real obstacle course: I could not take him in SAV in August but the store was on vacation, and then I went on vacation ... The unit has been repaired steam Amazon in September but took more than a month to send me the duplicate of the bill (I had lost the original) I have recovered in October.
And there SURPRISE he loses more water. This is the case and the generator have been changed.
So in summary if he loses too much water is that it is defective because it's really not the principle of a steam unit. Then a tip: if this is the case: return it to amazon or contact the customer service without delay domena of your city.

it loses much much water it is rather a boiling water unit as steam ... yet I always put the maximum pressure possible ... is this to say that mine is defective?
and it is really really noisy ....
qd I received it i had a doubt about the CEED reference.
I explain: on one side of the packaging is just wrote CS (CS4 and CS6 not just CS; and see the comparison chart between 4 and 6: we said we did well to take 4) and on the other side it says NVT (with a new comparison chart). a precise sticker NVTCS4 ... except that mine does not match any of the referenced table NVT ds. in short it is a detail but it disturbs me.
I will absolutely not find conclusive on the carpet ... my carpet is a shaggy (3-4 cm long hair), it may be to AC as it does not really work.
the electric wire connection does not curl (and therefore does not take place) automatically, as on one 1st prize vacuum ... he stayed at the back ds a cabin that will surely break dint of being solicited opening / closing.
missing rags for brushes ... there are only two (one for each brush) and it's really not enough. My tip: the great square microfiber cloths that I found in supermarkets. it works very well as ca.
Finally, we must attach the brush with what is called a gun ... you must select one of three desired positions using a cursor that is poorly thought out. positions are difficult to read and select. everything must be ds alignment (and that 's not specify ds the user manual). the cursor seems very fragile, kind gadget then it is essential (to fix or remove the brush etc)