Asked craftsmen

I have the table today assembled. That's why I can not say anything, of course, essential to quality. It looks sturdy. Certainly, a child can sit on it without it breaking. The height adjustment is infinitely but in steps of approximately 5 cm. At the lowest level the table top has a height of 64,5cm. Removing the screws for height adjustment it comes down to 63cm. Not propagated here 62cm.

The legs have no height adjustment. On our old floorboards shaking the table. Since I still have to look for a solution.

The assembly is not for the inexperienced. at least experience a la Ikea should be available. There are a lot M6 screws of different lengths, something to measure the length therefore is also helpful. An Allen and a 10-er open ended spanner are supplied. Both I have not used. The open-end wrench does not look trustworthy. I also took a ratchet, are just many screws. In addition, a Phillips screwdriver size 1 puller is needed that is not there. This 22 screws are placed in the MDF board. I took advantage of a cordless screwdriver. The pre-drilled holes for this were not so easy to see, and were not in perfect measure, so two screws are diagonally. When assembling, you can also use the help of someone who does what times.

The parts for the "pins groove" at the leading edge did not fit well. I needed to use a hammer and Holzkoltz. The bonding of the beech foil was (it's plastic, not veneer) on the bottom of the plate is carried unclean, but not visible.

Nevertheless, the eyes of our son who shone. The deductions are essential for the wrong altitude.

Conclusion: At least one should be skilfully, or get help.