Plus: It is very long, good range
Minus: It consists of three parts which are inserted into each other loosely. The connections do not last as well. Front a hard top, in the middle of about 40 cm flexible. then again a lot of hard, that fits on the intake manifold.
Minus: she is still very thick. This divorce also narrow vents of the car. The VW bus was on the ground as a "staircase Mice", the exhaust grille for the heater and in the tread an air grid for circulation. Behind this grid is always dust bunnies collect sand and dog hair, I would have liked terribly sucked away with a flexible crevice tool, but it is far too thick to fit through the 10 mm slots. Love Miele, because there is still room for improvement. Instead of this stupid hard plastic essay at the end of a super slim reducer would be announced here, so I pule still with pipe cleaners around in my ventilation grilles.
Thus the application in narrow, deep slots padding is done, if drawn out the plugged tip gets stuck in the cushion, merry shelling follows with his fingertips ... For the hard SFD 10 is better suited and also cheaper.
Use around the corner around in deep crevices between the furniture I find not so great, but it is too inflexible. But the total length is well suited to come into the kitchen finally just in the narrow gap between washing machine and dishwasher, with me are the 3 cm apart under the worktop, so the World Cup does not bump into. To get all the way to the back, however, it would be even longer, finally is the working surface depth of a standardized kitchen 60 cm. But the coarse crumbs are quite rare in the back .....
And since I now deeply to get back down to the windscreen when the suction fittings Tourrettes what the VW bus otherwise always long arms and soft hands, I need to keep it. I'm going to venture an experiment, the lace front soft heat with an industrial, poke a ruler as a spacer and the whole wide knock with a sledge .... Maybe I'll get it then so narrow that it fits in the slots, and if not, can the mashed piece simply saw off long enough they will still be .....
If I had not, however, VW bus, I would have returned to Amazon, for a little gap next to the washing machine I have to spend any extra money, the 30 cm nozzle does well.
Conclusion: Before ordering perhaps everyone should go and see where he has 56 cm deep and 2 cm narrow gaps with a critical eye and a ruler in his hand through his apartment. The nozzle is namely 18 mm thick, narrow joints are still unreachable ....