The only problem was the delivery, the machine has (have) been first delivered in an unknown places has almost 100 km of places registered with the right of commendation and after exchanging a few emails with the seller, the delivery person has recovered merchandise and delivered it in the right place but with more than a week late on the date originally scheduled. Some users have complained about the consumption of the brush cutter, and it is true that the setting "factory" is very rich, but I recommend using it as the first full 3 to 4 for break then on carburetor 2014 models there was only one pilot screw to adjust, you have the engine running, step on the gas thoroughly and at the same time tighten the screw slightly until wealth or motor rotates faster (not too long, so do not blow the engine), if you turn the screw too much the engine will "die", it will be too low and it will have "holes" in the acceleration. If the setting is done, you will see, it will consume much less.