well done without Schwirigkeiten in applying

I was looking for a method that electrically connects low (!) But effectively divided LED strips to these also lead to corners can. On the solution of a solid corner I wanted to do without, because me this is not flexible enough, especially when it comes to the length of the LED strip (between two corners I was not sure exactly a length where I just had to LED Strreifen to cm share). In addition, I noticed that these fixed corners are considerably more expensive. Although these quick connectors with cable have a long delivery time, but they fulfill exactly its purpose. The opinion of some reviewers that there are contact problems with the product, I could not understand. I have a 5m LED strips cut to perform this once a rectangle around the back of a shelf. The LED strip was additionally poured into Kunststff. This course must be carefully removed (Stanley knife or cutter). Even my LED strip had the backing of the adhesive bottom slightly offset it, so that the strip was better to use without protective film in the quick connector. I must admit, the insertion (the quick connectors have a guide for the LED strip) is a bit fiddly, but the contact is working fine and everything is lit in the same color, no matter how many quick connectors in between. Eder individual is approximately 180mm long, the connectors each 15mmx15mmx4mm (LängexBreitexDicke). The connectors are of course a little thicker than the LED strip, so that the LED strip on the plug can not rest on the ground, so do not even glued there.