Unauthorised off / on / switching
One notices determined that I do not quite know how to describe succinctly this "quirk". So, a longer description of the operation. That something must have happened, one sees that,
1
the time is adjusted, because a reset has occurred to 0.00 clock
2
the connected PVR hard drive is switched on (indicator light is on)
3
a servant of the looped antenna signal receiver only the sender can play that are on that transponder at home, which was recently received by Comag.
You have to turn on the Comag device, run a few minutes to rectify the time. After switching off, it is ok again. Also, the antenna signal is then looped back correctly. Unfortunately, this error is reliably reproduced within 2 days. This means that the timer settings, refer to the program in the longer term, will not run properly.
I have carried out a software update 2 days ago. There are no improvements occurred.
TIMER SETTING out of the EPG
It's actually very comfortable that timer settings can be made out of the EPG. Here then is not possible a manual correction or adjustment of the start bzw- end time. The manual confirms this: It says that this was unnecessary. What a mistake !!! Television is as punctual as the German Railway. If one wants to avoid the risk of missing out on more or less the end of a record, you have to be content with the less comfortable manual timer input take.
