- "Mounting frame" on are only three holes to fix a cavity wall box (right, bottom, left ... missing above a borehole)
- The design is something altpackend
- The regulation of the light intensity in my opinion is far from optimal:
one pressing with your finger on the sensor turns on the lights, press repeatedly it switches off (up to this point still fits all).
for scaling the light intensity you have to hold down the finger touch the surface when it reaches the brightest level, decreases the intensity again, so a cycle. so it may take a few cycles may, until you have selected the right light intensity.
- In all variants tested by me, unfortunately, is a constant hum (for the bedroom, study completely unsuitable) noticeable when the light was aktivert (it does not matter what light intensity is selected, it is humming always)
the following test types:
Cable cross-section: 1.5 mm² and 2.5 mm²
Bulb: Philips LED lamp, 60 watt (E27 base)
standard incandescent bulbs 40, 60 and 100 watt (E27 base)
standard incandescent bulbs 60 watt (E14 base)
GU10 (3, 3.5, and 5.5 watts)
halogen: G4 (20 watt) and G9 (40 watt)
2 stars from me ...