Also, my plate was after 15 months supposedly on the mind. I turned to the problem of the OCZ support and you have to let OCZ, customer service is fast and friendly, the right solution had ready. I put my support request via email and after an hour I got the answer: A firmware update fixed the allegedly defective panel. 2 points but you have to say yet, so I can only awarded 3 stars. 1. The implementation of Firmareupdates Although the OCZ Support Forum Step by step very well described (A MUST READ CAREFULLY each step) and it worked, but it must be observed many steps and perform. In the end, however, I had again a running board! 2. My data were naturally away because the OCZ however contained only my Windows installation, this was not all too big problem. But even this is a deduction in the B-Note. All newly-buyers, I recommend the firmware update before using it to perform.