First, a few words about the instructions, assembly instructions. Attach the saw table using the enclosed 3 screws with nuts and washers. (NB the left screw is easy to install when the table is in 45 ° slant.) they stretch the saw. Adjust the slope of the upper wheel using the screw back on (goes easier when the voltage of the saw only gradually erhöt, so tense, running examine further tension, etc.) Now set the guidance of the saw, this build the saw table please again, (the "please" I have attached. grrr I hate instructions !!!) with my saw is not allowed to set the lower guide, as the rail was bent such that nothing went. So dismantled the whole thing again, packaged, and back to the hardware store. Then everything happened at the second building much faster and easier by hand because I had already made my experience now. (For this whole hick hack I have the one star deducted) the saw itself is great, you can without any problems just lienien cut (think about it, the upper saw guide as close it comes to the material to be cut (wood with me, or hard plastic) introduce), also curved Lienen, or circles etc. for the saw no problem (in this case the upper saw guide to its top position, working my experience most) (NB have the saw brought from the hardware store, because she was to have because with 20%, which was below the price of Amazon ) for me is a good compromise between the Einhell band saw and scroll saw, I would buy them again at any time.