First RC Car that I have assembled:

- Instructions Top
- The processing of the components is impeccable, just had to pinch back after the contact points deburring with a utility knife.
- Various materials, soft plastic for "dynamic" parts, hard plastic where it needs to be rigid
- Have ever looked on the web for spare parts, Top choices and fair price
- Remarkable is the possibility to replace various components by wertigere, ie ball bearings instead of plain bearings Teflon, better shock absorbers, other wheels and so on ...

The assembly is to create good, thanks to the clean processing and very good guidance. But 2-3 hours you should already plan. Tool Chest It needs hardly ... Screwdriver, Side cutters, cutter ... the Miniinbus for set screws included.

The engine has bums ... the first test I leave on the tiles 1m rubber! But can rub off with a sturdy cloth then adjusted via the FB the ramp for forward and reverse ;-) Hab.

The power of Carson was a perfect fit. The assembly of FB, throttle, receiver u. Power is simpler than I thought.

The box moves my erachtes good ... but watch out that you do not use a front foreskin somewhere with speed ... then the pinion can slip on the steering servo.

Funny, I was only the wheels are suspended a little baggy, but these also have good ground contact.

Junior and Dad are thrilled!

Note: I would appeal to every child under assemble about 14, at least some things do not! To assemble the shock absorbers for example you need strong hands and must be able to run the Phillips clean ... if you could slip off the sit in the palm of your hand. Cuttermesser go fairly quickly through the skin ... and it would be good if you bring a little sense, I mean how much you which screw which attracts! After firmly comes off or the thread in plastic is dull. But all not so bad.