The unit is well made and fits due
the small size well into his pocket. Current-
supply by two AAA cells.
The laser beam is sharply focused, even when
Visible light and the ability to
To light corner, was enough for me. The
Alignment is not with the small dragonflies
so simple, it's still doable.
A small deviation in the alignment can but
already lead to an odd line.
The big criticism is the attachment to
the wall. Not everyone has as much steel in
the wall so that the unit holds by itself.
The supplied mounting plate, which is then to
Is used, can be secured in two ways:
1. Tape
Classic should be used here, the power strips of Tesa.
Unfortunately, these are relatively expensive and can not
be used again. It may also in other tape
happen that the color will be demolished after the measurement with.
2. "pins"
By Article 2 needles are provided which in the wall
be poked in order to secure the mounting plate. Here but
the diameter of the needles is about 1.5mm, to remain
the two mounting holes in the wall. Then looks at some point
even more for "Wall" as if by living room.
A good alternative is in my eyes the PCL1-cross lines
Laser from Bosch. This depends on the setting up itself
straight out so that the tedious Nivillierung deleted manually.
At the same time you get not only a vertical but also
a horizontally Line for's picture hanging. The dimensions are only
a little larger than the PLL5, but can still feed well
will.
OK, you need a tripod for the fitting, but who has not
already in the house for camera or camcorder ...