If the cube is accessible once the network and set up by WebApp, each deal with that. Simply click on the device long press (which key should be pressed, is the way hard to find, it's the BOOST button) and already the knobs, buttons or Fesnterkontakt is registered.
Everything comes before but is using software a disaster! Who knows nothing about IP addresses, ports and firewalls, the need either good luck (has all the correct settings), an IT study or someone on hand who is familiar with it. I am even programmers and technically very good at the thing, but something I have not experienced. In short - I have my network on the IP address need to change 192.168.0.xxx, so the cube is accessible.
If the hurdle succeeded in actually everything is going quite well, thanks to the super hardware. Even in our large duplex, all devices will be recognized immediately. To fix a radiator in a room, to suit any other at the new temperature - the wall thermostat so do not have to.
The iOS app worked perfectly so far with me, but when I look at the reviews me there is perhaps lucky. Who wants to do everything on the Internet, should possibly look for another solution for the "in-control" it is enough,
+ Hardware. Looks good, is well made, works
+ Wall thermostat can also attach without drilling
- Software Setup. Why do I need to install Java ?? Why is not DHCP ?? Why must run on the central server of the manufacturer all ?? Check out the better with every router manufacturers from how it is done properly.
