Rapid installation with forgetfulness

The engine comes with Anschluskabel on open ends and the rubber quiet running bearings in the set.

Have old Kunstoffrollläden equipped with it, you should watch only that the slats have a clean run in the guide rails. Top previously manually push the slats that everything runs smoothly, then converted to motor.

On the downside, after a power failure, the motor only its address (1-5) stores, but not the Enlagen. This must then be set manually with the remote control again.
You should clamp the motor at an unlockable line wwas in the old building is not always possible, however. We are talking about the problem described above, a space should times be unlocked, then the drive loses its Enlagen. Otherwise there are no problems so far.