I had the previous model, which already had a few decades under its belt and now finally gave up the ghost. This made an impression on the high end photos. There is also still a good machine that makes everything they want (I use it mainly for stirring dough), looks good and also makes a strong impression. But: - Going from a "transition" in the next Sets, she always makes a little break (will only very slowly and then faster - is not so bad, but my nerves). This has the old not made. - The maximum speed is much lower than that of its predecessor. I would like to have two stages that I could make up, so that the dough is stirred neat. - The operation is in direct comparison a bit louder, you would have to significantly raise their voice to talk - The stainless steel bowl is more beautiful than the old from cheap plastic. But it is inside brushed (?) And therefore very rough, which can be cleaned extremely poor. If the old bowl would fit, I would have used. - The bowl has a rear part, which is inserted into the machine (like the old). Front it is then, however, not on the countertop. That does not bother, as long as the bowl is empty. If it is filled unevenly (eg one forward purely puts a piece of butter, so that it is front heavy) or to get on the other hand, if one high represents the stirrer, it tilts forward. Yes, one can watch, but it's still annoying.
Positives: The "Nachstopfer", with which the material to be cut vegetables / fruit is pressed in the food processor, is now transparent and can also be used as a measuring cup. Now that's a good idea.