Hello there, I bought the monitor due to the technical data. Especially the IPS panel as a compromise between good image and still faster representation for games were the basis for purchase. The other technical data are good and deliver what the manufacturer promises. I have two criticisms. 1. The statement on the CINEMA SCREEN. I quote: "CINEMA SCREEN Thanks to CINEMA SCREEN design with an ultra-thin bezel width of only 1.2mm (in operation 10.8 mm) are virtually no side bezels recognizable thus provides a real viewing experience of this screen. " So really what I'm interested in the border width when turned off? Defakto Frame Width 10.8 mm (top and sides - down naturally a bit more). I'm sort of fell for this 1.2mm nonsense, since I have two monitors are side by side. Nevertheless, 1.8 cm a good value (ie less than the old LG). 2. I run the monitor to an ATI 6970 with current drivers. Initially, the image of the border was totally out of focus, about 3 cm wide. I have the whole evening trying to somehow (ie on the Monitor) korrigeren this with the monitor settings. My friend suggested already the monitor to send me back. Then, finally and at last, after hours I found out that one in Catalyst Control Center under My digital flat panel - must turn back> scaling options to underscan to 0 percent. Why this was so moved, no idea and I do had never happened at the monitors. This as a tip for the next who stumbles into this trap.
Conclusion: good device, inaccuracy in the product description (complaint 1) and a wicked stumbling block (complaint 2). I will also get my second monitor yet.
