The first few months was all good and we were pleased with the holder. Eventually I however then found that the arms of the holder were slightly downward. I then again everything bolted but the tendency remained. I have the old then rotated 180 ° so that the tendency now is facing up, and not down. After only about a month of the holder depended however through again. Noticed we have the right quickly, because the towels ever since slipped from the bars. We never more than 2 towels on the holder so that it also could not be caused by excessive weight.
I've looked at the holders now take a closer look and realized that the plate to which the boom is attached, therefore deflects deformed in itself. Since you can unfortunately no longer be improved by rebalancing. 1-2mm thicker material at this point would certainly be able to prevent the whole.
Are we now need to look for another towel rack and we will probably switch to a towel ring.
Too bad, because the adhesive principle is really good.
Best Regards
AlphaNerd