Appearance:
The heater looks good, as expected and shown in the pictures
Attaching:
There are two brackets here (one left, one right) that can be clicked on the back in a rail and then secured with screws. The brackets I found very pleasant, as these can be moved freely on the rail. So you need not necessarily be measured to the centimeter. Simply hold a spirit level on the wall, the two holders sit on the desired distance, Mark, brackets away, drill, screw it. Then click in the heater and secure with screws, finished. The only thing you can do is verkeht that is too far apart, the holders (quasi wider than the heater). Without fumbling and fiddling the thing is so attached.
Heating capacity:
I was disappointed at the first turn on. It takes about 1 minute until the wires glow and really comes heat. I knew of heaters at different friends that make and it will immediately warm. On the other hand, it takes a few seconds to the bodysuit is open until then, the Dink is warm. Dress better in advance for swimming.
Auto power off:
Works reliably after 10min.
Now the negative points:
Inclination angle:
The Neigungewinkel is under all. We already expected someone is at the angle of inclination tätsächlich past the most heat at the changing table - or in my face. Mir is so nice and warm, but the baby does not.
Fortunately, the brackets are fixed with two screws at top and bottom. So I cut off about 1.5cm thick wood, purely drilled a hole and used as a "washer" below the top bracket screw. Does not look fancy, but it works. The tilt angle will be much better. I measured on the changing pad temperature. Without the "washer" 1 ° C of warming. With the "washer" 3.5 degrees warming.
However, since he would be without the extra tinkering for the baby useless, I prefer it from 2 points.
So stay 3 points, but I have a nice warm face.