Top module here in Hardware Revision 1.0

This module runs at us properly in a Samsung TV, UE55C7700. After a firmware update on TV the module, however, was no longer automatically started and had every time after turning on the TV's rausgezugen and be reinserted.
I HAVE the mess BY SAMSUNG HERAUGEFUNDEN !!!
The new firmware allows the 5V supply voltage of the module short fall immediately after switching on 2V, so that it is not recognized !!!
Here's my solution: The housing of the module at the 2 corners "welds" aufdremeln / Files and gently bend (watch out for the chips!). In parallel to the pinning of the 5V supply (can be measured on Mr. Programier set) a small capacitor (470μF) at thin, outwardly guided Käbelchen solder (polarity) and protect Schrunpfschlauch. For Käbelchen small recesses must be created in addition to the card guide, nothing stuck. Install the module again and "solder", etc. (However, housing takes the solder bad "to").
The "dangling" capacitor "buffers" then the "Samsung's voltage drop", so I did not have the hardware revision 1.0, like many others replace ". He does not disturb me behind the TV really ....

Thanks Dad for the great "Tüfftlergene" ---> ... and I say Samsung Ätschibätsch, not me !!!

I wünschnsche every success during reverse engineering / Optimize!
Long live the Unicam Unicrypt module Rev.1.0 !!!