Total immature crap

At first glance, everything seemed, except for plastic adapters / rings, very Quallitativ. For each thermostat there was almost all possible adapters for attachment to the heater. The guide was good and fit.

Well, system set up and created weekly schedule on LANCube. But throughout the weekly schedule-create the cube could not be reached (internal network). I use a Fritz box and port clearances were active ... About another provider this system I have read in the support forum that since only the reset is necessary, in which all data is gone, of course.
Toll. So resets and everything reconfigured, investing several hours and the system was approximately stable for 2 months.

Today I wanted to adjust the temperature in the window opening. Have all changed locally, but the changes were not saved. The same tried over the web interface. No storage of data. Then I release the power from the Cube and behold, I can no longer connect to the cube. What shoud that?

Similar things I heard in the mentioned support forum by some customers ...

Another negative aspect is that the Cube does not have a web server, but that one locally is always dependent on the program on a computer which apparently simulates a web server and only stores the data in the cube. As recently was the web application of the system by a server failure broke, you had no way to access the system by the way. If the system has a built-in server, you would have to access by road to be private network .... but then not possible.

The app is also a letdown. One can almost only change the Manual temperature and switch between modes Eco, Comfort and car in the app at this time. More is not possible, no weekly plan, no nothing. Too Bad.

I strongly advise against purchasing, time you can invest some hours for next to nothing as a result, because you have to reset this anyway.