Uncomplicated evaporator which gets it right

One vornweg: I've tested various evaporator:
Sequentially:
1. Ego-T Type A (my entry)
2. Vivi Nova Mini (also with self-wound heads)
3. Smok 510 (cartomizer)
4. Innokin iclear 30
5. Innokin iclear 16

When it comes to processing the evaporator is rather simple. The lower part and the version of the mouthpiece are gefertig of metal, the tank itself is made of plastic, like most evaporators.

The filling is simple. You screw the mouthpiece from (Metal twist thread! This was not produced DripTips used) and filled the evaporator from above. It is once again important that no liquid reaches the middle. So always keep a slight angle and sideways incorporate the Liquid. One should the evaporator quiet sometimes turn a little, because the 4 threads the liquid at the edges of different rises. Then unscrew the mouthpiece again and finished. For capacity I write separately then some.
Allow the evaporator then rest a little (a few minutes), so that the threads can nicely soaked. Then he is ready, immediately produces steam and tastes equally good. It is noticeable that the vapor is very dense and is really difficult. I personally like a lot.
On a standard Ego-T Battery operation is already good. But its true splendor, he developed when one takes it up a bit in the voltage. In the ego-Twist at about 3.8 volts, the optimum is reached for me. The taste is strong again, the steam and the steam hotter development enormous for such a small part. You always have the feeling that this steam is somehow "close", very full-bodied and the taste just not as watered down. In combination with an ego-Twist This size fits very well. That looks really classy. The iclear 16 is available in different colors. an important distinction for the most ilear 30 is that he has a male thread for the standard first-port (ie the port 510). This is not you need this Cone to purely visual to bridge the connection from the evaporator to battery. It juts as formally through the battery Asnchluss about it and closes exactly on how the standard ego-evaporator.

The evaporator head has, as well as the iclear 30, 4 threads and draws thus neatly Liquid high. There are 2 coils in the evaporator head. So he is a true Dual Coil. Hence the really excellent vapor development. In contrast to the iclear 30 he has only one thread of the 4 sides. The head for the big brother iclear 30 has on all 4 sides 4 threads = 16, because it is just made for the yet clearly bigger tank. To replace screwing the mouthpiece off, then the tank from the bottom plate and ready. One can dasnn the evaporator head simply unscrew and screw on the new one. Due to the relatively small base plate there are - as opposed to large iclear 30 - no depressions in which liquid collects. So you do not suck up only with a handkerchief the rest. Once again very easily.

ATTENTION: It fit both vaporizer heads of the iclear 30 and from iclear 16 in both evaporators, since they are inside the thread of her and the longer ago the same. It remains a matter of taste what you use. After all, this is also important if your trusted dealer times has a shortage of supply. It is in each case also with the other. Personally, I find the taste of the evaporator head of the "small" iclear 16 better.

Visually the iclear 16 rather long put and looks just like a typical CE4 + CE5 or, in my opinion, but much better through the 4 threads at the 2 windings.

I mentioned that the evaporator is straightforward. This has several reasons.
1. The filling is super easy and is done in a minute.
2. It is this evaporation could not care less how your behavior is steam. Whether pulling it short, long, slow or fast, easy does not matter. He always tastes. He also does not kokelt he not Sifft and you have it does not continually swing back what I had often with the Vivi Nova. So good was any of the above evaporator.
3. The capacity is the evaporator as matter. Actually, you should fill up this evaporator as to the mark. Even that does not matter here. You can fill it almost to the limit, so that the mouthpiece just so it fits or almost completely empty steam, so you at the first mark on the metal edge barely Liquid looks down. Guess: Exactly! It is the steamer matter. He concentrated, tasty and just straightforward.

I have not thought it possible that a vaporizer actually can still combine all the important features in coming. This may. I am deeply impressed by the part. And by replacing the heads follow-up costs are also rather low. The purchase price for the evaporator is appropriate, is as good as he. In fact, he is even a little too cheap, MMN

Conclusion:
This evaporator is an all-rounder. It really shines in all disciplines and is my Erachtesn currently in terms of price / performance is by far the best thing you can buy. Who is it easy to buy a vaporizer and steam with little frills, just switch just once after a few weeks the head, he is perfect. For all undecided steamer among you and all who are still on the search for the ideal evaporator. Try the Innokin iclear 16 necessarily out! He is worth every penny. Even the biggest critics among you he will convince. Promised!

Pro:
+ Easy to fill
+ Very good steam Development
+ Very intense and mellow taste
+ Straightforward in every respect
Nachzukaufen + evaporator heads inexpensive
+ More colors to choose from
+ Connection via external thread, Cone no necessary

Con:
- Capacity of 1.6 ml for some perhaps too little
- Heads by twice winding not even be wound